Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger) (discontinued)

ICOM-1159-999
Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger)

Key features of Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger)

• Frequency coverage: 400-470MHz
• 16 programmable channels
• Powerful 1500 mW audio output
• Lone worker and man down function with built-in motion sensor
• Built-in SEL 2/5, CTCSS, DTCS coder and encoder, DTMF autodial
• Maximum 4W RF output power
• VOX function for hands-free operation
• Confirms with IP67 standard (waterproof and dust-tight protection)
• Equivalent to MIL-STD 810 C, D, E, F and G requirements
• Li-ion battery and rapid charger supplied as standard
• The device is used but in mint condition, of which 2 are available. There is no standard desktop charger for this article number! 1 used charger in mint condition is available under the article number ICOM-1160-999.

This product is not available.
Possible reasons that the product is not available from the manufacturer anymore or we decided to remove it from our product portfolio. We gladly help you to find the best optional product instead of this type, please contact us.

Further details of Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger)

• A new high efficiency FET of the IC-F1000 / IC-F2000 series reduces consumption current and provides 14 hours* of operating time with the BP-279, 1485mAh Li-ion battery pack. (Tx: 5%; Rx:5%; Stand by:90%)
• Easy to use due to the three main controls only. Transmit button, volume control and channel selector. This simple to use radio is ideal for high turnover environments and shift work where the radio is constantly passed from person to person. Additional 2 programmable function buttons are on the side of the radio. The LED lamp provides feedback for the user about the operation. (starting transmission, channel selection, etc.)
• The following features and settings are available with out any preprogramming: microphone gain, squelch level, beep level, ringer level.
• With the channel announcement function when you rotate the the channel knob, the radio announces the channel number. Convenient for making radio adjustements without having to look at the radio.
• The built-in inversion voice scrambler provides secure conversation. Up to 16 codes are selectable.
• Due to the built-in motion sensor both of the man down and lone worker functions are available.
• When the Lone Worker function is turned ON, and no operation is performed for the specified time period*, the transceiver enters the emergency mode, and then the countdown for the emergency call transmission starts. After the specified time period* has passed, an emergency call is automatically transmitted once, or repeatedly*. (*Depending on the presetting.)
• The man down function allows special emergency call. When the transceiver has been left in a horizontal position for the specified time period, the transceiver enters the emergency mode, and then the countdown starts. After the specified time period* has passed, an emergency call is automatically transmitted once, or repeatedly.* (*Depending on the presetting.)
• Limited MDC 1200 features and compatibility.
• Maximum 16 channels can be programmed into radio.
• The 5-Tone signalling (encoder/decoder) gives you selective calling, quiet stand-by and other convenient functions with programming. The radio “stun” function disables a radio over the air and the “revive” function restores the stunned radio.
• Built-in SEL 2/5, CTCSS, DTCS coder/encoder and DTMF autodial.
• Channel spacing: 12.5/20/25Khz; PLL channel step: 2.5, 3.125Khz (VHF); 5, 6.25Khz (UHF)
• 2-step power save
• Low battery alert
• Time-out-timer (TOT): The time-out timer limits continuous transmission time period to prevent accidental prolonged transmission.
• The priority scan allows you to monitor one or two priority channels while scanning other non-priority channels. The Tx channel and talk back functions allow you to make a quick response while scanning.
• The built-in bridge-tied load (BTL) amplifier offers powerful 1500mW* audio output from the large 36mm speaker. The radio delivers loud and intelligible audio even in noisy environments.
• Surveillance mode (turn off LED and beep)
• Confirms with IP67 standard (waterproof and dust-tight)
• Equivalent to MIL-STD 810 C, D, E, F and G requirements
• Electronic serial number

Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger) related media

Icom IC-F1000 és IC-F2000 kézi URH rádiók bemutatása

Standard Accessories of Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger)

Icom BP-279 1570mAh Li-ion Battery (discontinued)


This product is not available.
Possible reasons that the product is not available from the manufacturer anymore or we decided to remove it from our product portfolio. We gladly help you to find the best optional product instead of this type, please contact us.

Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger) related products

Icom Headset and Audio Accessory

Albrecht and Midland Headset and Audio Accessory

Icom Programming Software And Cable

Icom Battery and Battery Case

Icom Battery Charger, Adapter, Power Supply

Icom Antenna and Antenna Accessory

Icom Carrying Case and Belt Clip

Headset for Icom, Alan, Albrecht and Midland Radios from other Brands

Icom Hand Microphone

Albrecht and Midland Hand Microphone

Hand Microphone for Icom and Albrecht Radios from other Manufacturers

Icom Mounting Bracket

Accessory, Spare Part and Hygiene Kit

Icom IC-F2000 UHF Two-Way Handheld Radio (used, without charger) related discontinued products

Discontinued Icom Products

Discontinued JDI Products

Discontinued Midland Products

Discontinued Voxtech Products