Midland CT990-EBR Handheld Amateur Transceiver Radio
Key features of Midland CT990-EBR Handheld Amateur Transceiver Radio
• TX and RX frequency: 144-146 MHz and 430-440 MHz
• Selectable transmit power: 10 W or 5 W
• 257 memory channels and VHF/UHF dual-band display
• IP67 protection against dust and immersion in up to 1 m of water
• 3600 mAh, 7.4 V Li-ion battery with up to 21 hours operating time
• Colour TFT display and support for Dual PTT accessories
• Supplied with two antennas, charger, adapter, belt clip and wrist strap
Further details of Midland CT990-EBR Handheld Amateur Transceiver Radio
The Midland CT990-EBR is a dual-band VHF/UHF handheld amateur transceiver operating within the 144-146 MHz and 430-440 MHz transmit and receive frequency ranges. The radio may only be operated with an amateur radio licence. Selectable 10 W or 5 W transmit power, 257 memory channels, a colour TFT display, Dual PTT support and a 3600 mAh battery provide configurable operation for a range of radio communication tasks.
Midland CT990-EBR VHF/UHF frequencies and operating modes
• Transmit and receive frequency range: 144-146 MHz and 430-440 MHz
• The frequency band must be set according to the country or region of use
• Dual-band VHF/UHF display
• Selectable operating modes: UHF-VHF, VHF-VHF and UHF-UHF
• Frequency mode and channel mode
• Simultaneous display of two frequency bands
• Main frequency for transmitting and receiving
• Secondary frequency for receiving
• The main frequency can be selected between the two displayed frequencies
• Channel mode can display the channel number, frequency or channel name
• 257 memory channels
Frequency mode and channel mode can be selected using the radio controls or the optional programming software. Certain settings, including the scan list, priority channel and channel name, are only available in channel mode.
CT990-EBR transmit power and frequency settings
• Selectable transmit power: high, 10 W or low, 5 W
• The selected transmit power level is shown on the display
• Selectable channel spacing: 25 kHz or 12.5 kHz
• Selectable frequency steps: 0.5 kHz, 2.5 kHz, 5 kHz, 6.25 kHz, 10 kHz, 12.5 kHz, 25 kHz, 37.5 kHz, 50 kHz and 100 kHz
• Selectable positive or negative frequency shift
• Frequency shift can be switched off
• Adjustable frequency offset: 0-99.995 MHz
• Selectable wide or narrow bandwidth: 25 kHz or 12.5 kHz
• Reverse frequency function
• Repeater shift function
• Transmission of a 1750 Hz repeater tone
The frequency offset allows different transmit and receive frequencies to be configured. Transmission is only possible when the configured transmit frequency and frequency offset remain within the permitted frequency range of the radio.
Midland CT990-EBR Dual PTT operation
• Dual PTT function with an external accessory
• Transmission on the main A band or secondary B band
• The two configured radio channels can be controlled separately with a Dual PTT accessory
• No manual frequency switching on the radio is required
• Compatible with Midland MA21LK Double PTT and MA31LK Double PTT accessories
• Dual PTT earpiece is not included
• 2-pin Kenwood type external speaker and microphone connector
When a conventional speaker microphone with a single PTT button is used, transmission takes place on the currently selected frequency band. A Dual PTT accessory enables direct selection of the A or B band. The function can be disabled when no external Dual PTT accessory is connected.
CT990-EBR signalling and selective calling
• 38 CTCSS tones
• 83 and 83 DCS codes
• CTCSS and DCS settings for reception and transmission
• Identical CTCSS or DCS setting for transmission and reception
• CTCSS and DCS search function
• DQT function for private conversations
• Individual and group selective calling
• Reception of DTMF messages
• Identification code verification
• PTT-ID transmission at the beginning, end or both stages of transmission
• Repeater tones
• Roger Beep end-of-transmission tone
• Sidetone noise suppression at the end of transmission
The Busy Channel Lockout function prevents transmission when the selected channel is busy. When the function is enabled, pressing the PTT button does not initiate transmission on an occupied channel.
Midland CT990-EBR voice control and scanning functions
• VOX voice-operated transmission
• Adjustable VOX sensitivity level
• Adjustable VOX delay
• Scan function
• Addition of channels to the scan list
• Adjustable priority channel
• Dual Watch function
• Adjustable transmit priority
• Monitor function
• 10-level squelch adjustable from 0 to 9
• TOT, or Time-Out Timer
• FM radio
• Adjustable FM radio interruption
The squelch level can be adjusted according to the strength of the received signal. A higher setting can filter weaker signals, while a lower setting may allow more noise or unwanted signals to be heard.
CT990-EBR display and controls
• Large colour TFT display
• Simultaneous display of the main and secondary frequencies
• Memory channel display
• VHF/UHF operating band display
• Battery level indicator
• High or low transmit power indication
• Wide or narrow bandwidth indication
• CTCSS and DCS status indication
• VOX, Scan, Man Down, FM radio and keypad lock status indication
• Adjustable backlight and brightness
• Alphanumeric keypad
• Rotary channel selector
• Combined power switch and volume control
• VFO/MR button for switching between frequency and channel mode
• Separate PTT, Call and Monitor side buttons
• LED indicator showing transmission in red and reception in green
The content displayed at power-up can be configured. Available options include no logo, battery voltage, a welcome message, a Midland image or the model name. The welcome message can be edited with the alphanumeric keypad.
Midland CT990-EBR safety and monitoring functions
• Man Down function with built-in tilt sensor
• Alarm if the radio remains tilted beyond the configured period
• Preliminary warning tone before the alarm is transmitted
• Alarm tone transmitted on the configured frequency
• Integrated emergency alarm function
• Automatic or manual keypad lock
• Function and channel reset
• Voice warning for low battery level
• Battery voltage display
• Selectable power-on tone or voice announcement
• Keypad tone on or off
The Man Down function continuously monitors the position of the radio. When the radio is tilted, it initially emits a warning tone and then transmits an alarm if it is not returned to its normal position within a few seconds. After the alarm stage, the radio returns to receive mode.
CT990-EBR IP67 construction and battery
• IP67 rating
• Protection against dust
• Protection against temporary immersion in water up to 1 metre deep
• Water immersion for up to 30 minutes
• 3600 mAh Li-ion battery
• Battery voltage: 7.4 V
• Up to 21 hours operating time
• Receive power-saving function
• Desktop charger
• The complete radio or the separate battery can be charged in the desktop charger
• Full charging time: approximately 5-6 hours
• The charger LED shows red during charging and green when fully charged
The battery can be charged with the supplied desktop charger and mains adapter. The charger accepts both the switched-off radio and the battery removed from the radio.
Midland CT990-EBR package contents
• Midland CT990-EBR handheld transceiver
• 39 cm long antenna
• 17 cm short antenna
• 3600 mAh, 7.4 V Li-ion battery
• Desktop charger
• Mains adapter
• Belt clip
• Wrist strap
An earpiece for Dual PTT operation is available separately and is not included with the standard accessories.
